MENU
Toggle navigation
Products
FreeStyle 8400™ Interlocking Floor System
ESD Vinyl Tile
8400 Series Conductive ESD Vinyl Tile
8400 Series Dissipative ESD Vinyl Tile
FreeStyle 8400 Interlocking Flooring System
7900 Series Conductive ESD Vinyl Tile
Modular Conductive Interlocking Floor Tile
ESD Modular Carpet Tiles
Colonial Series
Discovery Eco Series
Landmark Series
Presidential Series
Adhesive and Grounding Strips
Conductive Rubber Tiles and Rolls
Conductive Adhesive, Grounding and Weld Rod
Dissipative Floor Finishes
Statguard® Low-VOC Dissipative Floor Finish
Statguard® Dissipative Floor Finish
Statguard® Floor Label
ESD Floor Maintenance Products
Statguard® Floor Stripper
Statguard® Floor Neutralizer
Statguard® ESD Floor Cleaner
Statfree® Dissipative Spray Buff
Statfree® Burnishing Restorer
Measurement Meters
Statguard® Conductive Epoxy
New Products
Resources
Partners
Webinar
Videos
REGISTER / LOGIN
SHOP
CART (
0
)
SUBSCRIBE TO OUR EMAIL LIST - Be the first to know
about exclusive deals, tips, new products & more!
Questions And Answers
#
167
List All Questions
Search
List by Category
Question
If two charged dielectric materials, of opposite or same polarity, are brought to close proximity of each other, will there be a transfer of charge from one material to the other. And, does the introduction (contact) of a reference ground impact the decay time of the ESC on these materials? - Anonymous, San Jose, CA
Answer
If two charged dielectrics (insulators) are brought into near proximity or contact, typically there will not be a transfer of charge (free electrons) from or to either because they are very poor conductors. If the charge imbalance is concentrated in a small area and the corresponding electric field is rather substantial, then there is a chance that the air will become a conductor and a breakdown will occur. More common with dielectrics holding large electric fields is that the field is more deadly to an ESDS device then an ESD event may be. The electric field emanating from the external dielectric (e.g., styrofoam cup) can cause the dielectric inside the ESDS device (SiO2) to breakdown (burn holes, or cause the circuit to fail). Bringing a reference ground in near proximity or contact to the charged dielectric may suppress part of the field (cause it’s magnitude to be temporarily reduced) but will not discharge the charge imbalance or have much of an effect on the decay time of the charge imbalance.
Related Categories:
Shielding
If you have found this Q/A useful, please rate it based on its helpfulness.
This question has been rated:
(
80
% at
1
Ratings)